View Single Post
Old Dec 19, 2011, 07:56 PM
gioial is offline
Find More Posts by gioial
Registered User
Joined Feb 2008
41 Posts
Quote:
Originally Posted by erh7771 View Post
I've an MB1 and SAPAC knock off fan and feel it's a tad tail heavy but there's PLENTY enough room in the bat tray for even a 5s 3300mah.

Some tips maybe not in the thread

Use heavier gauge steering wire and secure steering servo well to prevent bending of front landing gear strut wire. I use the round servo arm cause it's always been the toughest and doesn't break on "aggressive landings"

Clear tape the rudders and lending edges of wing, it'll toughen them up 3 fold and wont add too much extra weight or hide the looks of the plane any. I did this to my Windrider F35 which is a low density light EPS and they haven't snapped once even though I've flipped it a couple of times.
Thanks for the information. I was a little worried about the heavier Lander setup, but suppose I could balance it out with the appropriate bat. UPS status shows they received a shipping label. I don't believe it will arrive before Xmas using ground shipping...
gioial is offline Find More Posts by gioial
Reply With Quote