Thread: Discussion 2.4 Meter Horten VII
View Single Post
Old Dec 17, 2011, 01:07 PM
birdofplay is offline
Find More Posts by birdofplay
Registered User
birdofplay's Avatar
United States, IN, Indianapolis
Joined Dec 2005
9,516 Posts
OK back again with the current batch of canopy carvings.

I split out a 12 x 12 top view then added some surface to the rear of the canopy
with a tiny ridge separating them as a cutting line.

Then I rotated everything and then split off the protruding read canopy section.

All is shown on a 12x12x.75 mdf base.

Export to STL and process the Tool paths from there.

eh ???

Bob
birdofplay is offline Find More Posts by birdofplay
Reply With Quote