View Single Post
Old Dec 14, 2011, 12:02 PM
m_beeson is offline
Find More Posts by m_beeson
FPV junkie
m_beeson's Avatar
United States, UT
Joined Jan 2011
3,603 Posts
Quote:
Originally Posted by aaronredbaron View Post
BEC voltage is solid, and all the grounds go through the Elogger, ie, when i first had it set up there were some ground loops (ground through both servo lines and elogger, and ground through the video out and Elogger) I was able to disconnect the ground from both BECs outputs because they are both already grounded at the source, didn't seem to make any difference either way...

Aaron,

Do you have your LC Filter placed like this?
m_beeson is offline Find More Posts by m_beeson
Reply With Quote