Originally Posted by 376782
Can you please tell me what you mean by "The trick I have found though is to leave the pins tripped in the ON position otherwise it will trip an error if just left to sit in standby, as it spins too slow in this mode and sees it as an error."
I have several of these supplies and really need to slow down the fans before I can use them. I have tried resistors but do trip out on low fan speed.
I mean connect all 3 of the pins (JR servo lead wires) together and leave it that way, no switch. Plug in AC power to turn on, unplug AC to power down. Have charger connected prior to powering up system.