View Single Post
Old Dec 11, 2011, 11:14 AM
Widelec is offline
Find More Posts by Widelec
Simple is the best
Widelec's Avatar
Joined May 2011
1,207 Posts
Quote:
Originally Posted by WiseDuck View Post
I just noticed something here. The top plate which is supposed to protect the electronics isn't big enough to protect larger boards such as the Crius and KK ones. (45mm between mounting holes) So my board will be unprotected. Also, the bottom board that the motors are mounted on don't have the same set of extra holes as the top plate (Those meant for KK boards and similar) so you have to use the nylon spacers like so:

Perhaps something to think about for the next revision. Still, I like the frame! The rest of the parts should be here tomorrow, then I can finally test it.
WiseDuck you're right
Protector Top plate orginally for 30.5mm board hole.
But many of 30.5mm board out off stock.
I add 45mm hole on Upper plate after the first relase.
Pre drilled for who want use other big board.

(You can clean nylon with wood stick on the bambucopter writing)
Widelec is offline Find More Posts by Widelec
RCG Plus Member
Latest blog entry: Asterix Brushless Gimbal v2r
Reply With Quote