View Single Post
Old Dec 09, 2011, 11:43 PM
wojtek is offline
Find More Posts by wojtek
never fast enough !!!
wojtek's Avatar
old bridge, nj
Joined Nov 2004
258 Posts
Quote:
Originally Posted by Wayne Giles View Post
I have just bought and converted an HP Power Supply DPS-600PB and it works fine. As it is difficult/impossible/expensive to obtain the mating rear connector, I have soldered a couple of 4mm test sockets between the blades of the existing connector which makes a convenient termination.
The extra low Z capacitor is only to reduce pk - pk ripple to about 60mV at full load and not strictly necessary.
BTW I think the only real ground pin is pin 8 which pins 6 and 10 should be commoned to in order to enable the main 12V output. Full Load regulation is only 0.11V and the overload characteristic is trip off at about 56A, break input to reset.
So as I paid 9.50, I now have a good 12V, 50A psu for just over a tenner!, ($16)

Wayne

im glad i found this post .. thank you!! .. I have a few of these power supplies and could never figure out how to get the 12v out ..

Voy
wojtek is offline Find More Posts by wojtek
Reply With Quote