View Single Post
Old Dec 08, 2011, 08:52 PM
iseekk is offline
Find More Posts by iseekk
Registered User
iseekk's Avatar
Joined Nov 2011
30 Posts
2. Hardware installation

“X” mode


“+” Mode

And we will find “X” mode and “+” mode is the same installation in the Coptor ,the only different is Mode config of FF on software.

Important Note: Instruction for Use: as it may be dangerous when the aircraft is in the debugging process, please make sure the propeller is unloaded when it is in the debugging process.
Installation Method:
According to the map tips,install the FF on the aircraft (the aircraft head orientation should be consistent with Y direction on the fly control board), connect 5 lines between the receiver and Fly control board input channels( black line is the cathode”-” near the board edge, the red line is 5V, the white line is a signal line ), confirmate before connecting on the power line (red thick line to 3S Battery anode”+”, black thick line to 3S battery cathode “-”). At the same time set the remote control 1-4th channel to reverse output.After confirming again each wiring,turn on the remote controller power supply firstly and then the fly control board main power supply,at this time,the blue light is normally on,the red light flashes 3 times,the buzzer rings once.
iseekk is offline Find More Posts by iseekk
Site Sponsor
Reply With Quote