View Single Post
Old Dec 08, 2011, 08:34 PM
iseekk is offline
Find More Posts by iseekk
Registered User
iseekk's Avatar
Joined Nov 2011
30 Posts
Installtion Guide

Quote:
Originally Posted by WiseDuck View Post
Huh, I would like to know more too. That looks very interesting. 50 bucks for something with auto-leveling and a LiPO alarm? I want that.
1. Computer Setting
The FF(Free Flight Controller,Below same)board default setting is "X mode"+Start from static,10.8V below volatge alarm enable,if you need change some setting,should use the Upper machine and software to make some setting you want.
first Connect the 3S battery to FFby JST connector,must "+" positive pole of battery,"-"nagetive pole of battery,then the green led on,link the FF by the rainbow cable and usb abaptor board(make sure the swith on the adaptor board is near mini USB connector side)
Install the USB Driver,(if your OS is win7 may not need the driver),then find the COMx (here is COM4) in "device manager" ,then install upper machine software on your computer,Run the software,like below


then config right serial Port,(here is Com4 for us),then Click Open,you will connect the software to the FF,and now you can make right config on the Board
iseekk is offline Find More Posts by iseekk
Site Sponsor
Reply With Quote