View Single Post
Old Dec 08, 2011, 09:03 AM
kingconsulting is offline
Find More Posts by kingconsulting
Registered User
kingconsulting's Avatar
United States, CA, Long Beach
Joined Sep 2011
928 Posts
Thanks for posting that I forgot about that link. I never noticed you had the sketch up files there.

At one point I thought about using thinner wood but the plans say the original was 2lbs. So I figure minus heavier motor, tank and one servo I should be a tad under the 2lbs. I always figured I would get a motor that is the equivalent of a .25.

The supreme uses different wood sizes than the 3 channel one. Wingspan is about the same but the fuse is a little larger.

Robert

Quote:
Originally Posted by rcav8r2 View Post
The Pronto has always been one of my favorites. I built one a few years back for electric. I used 1/16" balsa all around. Turned out it was too light/thin/weak. Fuse would torque causing all sorts of flying issues under power One of these days, I'll build a new fuse.

Here's my post from the thread Robert mentioned: http://www.rcgroups.com/forums/showp...1&postcount=60
kingconsulting is offline Find More Posts by kingconsulting
Reply With Quote