: Build Log
PaintBall Wing- All purpose Foamie Flying Wing.
View Single Post
Dec 07, 2011
, 08:48 PM
Home of "Golf Cart Flying"
Joined Aug 2008
Here are some build pics on the last one I did.....
View all Images in thread
Make sure and use the door and window type foam
the strings are to later pull the aileron wires thru the wing. You can see the spar joiners bent in the middle. You can see the bamboo skewer at the leading edge. this really strengthens the nose.
I taped in the corner and added a meat skewer for strength in this area.
1 side done,fixing to close up the other side
The green tape is about where a hatch will be cut to install receiver and ESC
Hatch-cut as desired- I go a little bigger than this now.
2100 3S battery is perfect match for CG and looong Flights
I shot a little more foam up in the nose for strength. Cut it back out to fit battery back in. There is a battery shelf that gets added, see plans
Battery shelf, glue in to give a nice flat place for Velcro
Ready for Maiden- Note: Tyvek tape is bad to the bone! but ugly
Just do it. However the heck ya want
Beer and Nascar de-gays the pink a little bit. LOL
Last edited by pecanpatch; Dec 07, 2011 at