View Single Post
Old Dec 02, 2011, 04:41 PM
Model Aero is online now
Find More Posts by Model Aero
Registered User
Northwest Ohio
Joined Jan 2002
2,747 Posts
Quote:
Originally Posted by bz1mcr View Post
Scott,
Thanks for adding your usage and your comment. I agree 6 mm would be the best target thickness for the initial product with perhaps 3 mm following later.

I am guessing that Kens initial request for 5 mm was because it is closer to the Dollar Store "Ready Board" and the Dow protection board which are current products from this manufacturer. But again, I agree a 6mm sheet would be a better choice, unless it results in some extra tooling or other expense.

By the way are 2'x4' sheets an exceptable size for you?

And how about 23.5"X4'? That is favored by some Phlatprinter users.
I have to cut the sheets down to 23" x 34" fit the laser so anything larger than that could work. I have laid out the kit parts to use the cutoffs for some of the smaller parts. So there is very little waste from the full size Depron sheets.

Personally I'm not sure if I'd be interested in 5 mm foam. It just wouldn't work well for our kits.

Scott

www.ModelAero.com
Model Aero is online now Find More Posts by Model Aero
Reply With Quote