View Single Post
Old Dec 02, 2011, 06:38 AM
dz1sfb is online now
Find More Posts by dz1sfb
Slipping the Surly Bonds
dz1sfb's Avatar
Attica, MI
Joined Dec 2006
11,414 Posts
Quote:
Originally Posted by rcav8r2 View Post
FWIW, as a PhlatPrinter owner, the 2'x4' works just fine.
When designing in SU for FFF, I use 6mm as the standard for the tabs, slots, and about 85% of the time that works just fine. It does vary a bit even on the same sheet (long piece with multiple tabs/slots, most are perfect fit, some aren't)

Also 5MM would be fine with me, but I would prefer 6mm and then 3mm as a close second.
Ditto!

Ken
dz1sfb is online now Find More Posts by dz1sfb
RCG Plus Member
Latest blog entry: Mini H Quad Project
Reply With Quote