View Single Post
Old Dec 01, 2011, 10:27 PM
rcav8r2 is offline
Find More Posts by rcav8r2
Registered User
rcav8r2's Avatar
United States, PA, Beaver
Joined Sep 2001
3,524 Posts
Quote:
Originally Posted by bz1mcr View Post

And how about 23.5"X4'? That is favored by some Phlatprinter users.
FWIW, as a PhlatPrinter owner, the 2'x4' works just fine.
When designing in SU for FFF, I use 6mm as the standard for the tabs, slots, and about 85% of the time that works just fine. It does vary a bit even on the same sheet (long piece with multiple tabs/slots, most are perfect fit, some aren't)

Also 5MM would be fine with me, but I would prefer 6mm and then 3mm as a close second.
rcav8r2 is offline Find More Posts by rcav8r2
Reply With Quote