View Single Post
Old Dec 01, 2011, 08:06 PM
bz1mcr is offline
Find More Posts by bz1mcr
AKA Don
bz1mcr's Avatar
United States, MI, Houghton Lake
Joined Dec 2002
7,746 Posts
Scott,
Thanks for adding your usage and your comment. I agree 6 mm would be the best target thickness for the initial product with perhaps 3 mm following later.

I am guessing that Kens initial request for 5 mm was because it is closer to the Dollar Store "Ready Board" and the Dow protection board which are current products from this manufacturer. But again, I agree a 6mm sheet would be a better choice, unless it results in some extra tooling or other expense.

By the way are 2'x4' sheets an exceptable size for you?

And how about 23.5"X4'? That is favored by some Phlatprinter users.
bz1mcr is offline Find More Posts by bz1mcr
Reply With Quote