Thread: Discussion TopFlite Cessna 182 Skylane
View Single Post
Old Nov 29, 2011, 11:12 PM
stegl is offline
Find More Posts by stegl
stegl
Kelowna , BC
Joined Nov 2008
2,716 Posts
Cessna 182 kit

Here are a couple of pictures as to what I have done to replace the front reinforceing ply strip for the main landing gear . The front 5.5 inch piece I will cut out and replace with a battery axcess door that is a bit narrower than the ARF version and should still give me enough room to install and remove my batteries . The door will be about 5 inches long by estimated 3.5 inches wide. I will go wider if necessary. The support has not been removed in this picture yet but with it out of the way I should not need as big an opening as the ARF version.
stegl is offline Find More Posts by stegl
Reply With Quote