View Single Post
Old Nov 27, 2011, 02:44 PM
BalsaBasher is offline
Find More Posts by BalsaBasher
Registered User
United Kingdom, England, East Horsley
Joined Dec 2004
23 Posts
Quote:
Originally Posted by DoctorG View Post
Hi Balsa Basher (nice!)

I sheeted top and bottom to the same outline as I figured it would help keep the covering neatly in place. If you haven't already done it go carefully around the top LE where you get a relatively large curvature in two planes. I ended up with split sheeting on one and had to redo it. I found the trick is to be prepared to cut thin wedges out of the sheet as you offer it up to the curve. Once you are happy with the curve the sheet will take up throw tradition out of the window and apply the cyano!
Thanks for the advice I also ended up cutting a thin wedge out of the top leading edge sheeting. I reinforced the area underneath by sticking a piece of sheeting across the cut. I am going to extend the sheeting on the underside all the way to wing tip as it is nearly flat and will strengthen the tip. I may just add some block on the top to extend both spars to the tip.

I'm going to put in an ASP 80FS.
BalsaBasher is offline Find More Posts by BalsaBasher
Reply With Quote