View Single Post
Old Nov 27, 2011, 01:54 PM
zavataafnan is offline
Find More Posts by zavataafnan
Registered User
Joined Nov 2011
5 Posts
You know, I think the quad can not program well. I can not see the red LEDs describing the configuration of each THROTTLE, PITCH, ROLL, and YAW.
But when i set the trim for throttle to the lowest position, the quad starts and stops well. But i can not use throttle to fly the quad.
Can you help me about the receiver connection pins. I use this setting:
PIN10-> CHANNEL 6(THROTTLE)
PIN9-> CHANNEL 5(PITCH 2)
PIN8-> CHANNEL 4 - NO CONNECTION
PIN7-> CHANNEL 3 (PITCH 1)
PIN6-> CHANNEL 2(ROLL 2)
PIN5-> CHANNEL 1(ROLL 1)
is that right?
I really confused!
zavataafnan is offline Find More Posts by zavataafnan
Reply With Quote