View Single Post
Old Nov 27, 2011, 01:25 PM
ripmax is offline
Find More Posts by ripmax
Registered User
ripmax's Avatar
uk. northampton
Joined May 2009
1,051 Posts
Safety first, remove the props whilst you are setting, only when it responds as expected fit the props!

Do you have a 35mhz transmitter or 2.4ghz? if you have 2.4ghz it will have a very short stubbie areial, 35mhz will have long metal telescopic areial, don't matter which just pull areial out,disconnect the battery from the quad and plug the jumper into r2, set all trims to neutral, throttle to zero (pulled back to bottom) then follow manual to programme your transmitter to the quad, make sure u remove the jumper from r2 when this has been done (before flying)
ripmax is offline Find More Posts by ripmax
Reply With Quote