View Single Post
Old Nov 25, 2011, 05:33 PM
jjh24 is offline
Find More Posts by jjh24
Registered User
jjh24's Avatar
soKali, Chino
Joined Mar 2010
172 Posts
Originally Posted by fredmdbud View Post
What radio setup are you using?

Usually once you power up the RX with the bind plug, you turn on the TX with the bind switch - don't wait. Once the TX-RX are bound, remove the bind plug and disconnect the battery. Then reconnect the battery, the RX should bind, and *then* make the beeping sounds.
your using my dx6i with a orange rx (with a satillite) i used with another plane..but i didnt erase the old settings from the other plane..i thought the bind plug would do that..but once i did that and reset everything it binded..THANKS

...but why did it beep like 5 times after a few seconds. i waited for a few seconds and it didnt i started over and didnt wait and it bound right up..

i want to learn more about how to program the esc and the beeps..ill do some research..THANKS FOR YOUR HELP
jjh24 is offline Find More Posts by jjh24
Reply With Quote