View Single Post
Old Nov 24, 2011, 03:31 AM
Roto Rob is offline
Find More Posts by Roto Rob
Registered User
Denver, CO
Joined Dec 2005
6,907 Posts
I haven't taken my spindle bearings out.
On other spindles I have done it can be a challenge, or go easy. Usually I had to heat up the spindle in the oven, to make it easier to press out. Sometimes it pushed the lower bearing out with the spindle.
You might get some info from calling Intelitek. Last number I had was 1-800-221-2763. Please post any good info you find. Might want to ask about the preload settings.
Roto Rob is offline Find More Posts by Roto Rob
Reply With Quote