View Single Post
Old Nov 22, 2011, 08:53 PM
Swarfmakr is offline
Find More Posts by Swarfmakr
Registered User
Joined Nov 2011
1 Posts
Hello,
I'm trying to remove the spindle from my Prolight 2000 (it's galled and I need to clean it up). I've removed the pulley and tried to gently press it out of its bearings but it doesn't want to budge. Before I press it out more firmly (and maybe regret it), is there anything that I'm missing? Is it just a tight press fit into its bearings?

Regards
Swarfmakr is offline Find More Posts by Swarfmakr
Reply With Quote