no, calibrate them to the reciever
I also get my engines calibrated perfectly in 1 step -> using this combo-calibration-Wii lead I made (below) -
So I now can program all Six/four/Three engines in a single step - hooked direct to the Tx/Rx THRO port -
follow your owners manual ESC calibration procedure : -
Full Throttle ->
PWR to ESC on ->
2 Beeps ->
Throttle to idle ->
3 Beeps - Done!
This is only used to calibrate all engines so the props turn at exactly the same time - it is not used for flying!