Thread: Discussion RSSI pins for various receivers
View Single Post
Old Nov 22, 2011, 11:43 AM
squishy654 is offline
Find More Posts by squishy654
Registered User
squishy654's Avatar
United States, CA, Sacramento
Joined Jun 2010
672 Posts
Quote:
Originally Posted by patricklupo View Post
Here's the RSSI pin for the Hitec Supreme IIS 8 channel receiver.

100% Signal = 0.680 volts
0% Signal = 0.150 volts

Not much range in voltage but my RVOSD seemed to provide a good bit of resolution between full and no signal. In the second picture, I sacrificed the 8th channel to turn it into an RSSI output, by cutting the servo out PCB trace going to the 3 pin servo connector and then running a 100K ohm 1/8 watt resistor to it instead.

Thanks very much Renatoa for providing the RSSI pins to commonly used receiver chips!
Thanks so much for this!!
squishy654 is offline Find More Posts by squishy654
Reply With Quote