Originally Posted by kaz1104
The Y6 is the next thing on the table. Weighing up which flight control board to use.... too many choices. Motors are a question too. Was almost settled on the KDA 20-22L but the CC quad I just finished has rctimer 2830/14 750kv motors swinging 10x4.7 (or 4.5?) Have to say I'm pretty impressed with them. I just shortened the motor shafts so that the propeller collets sit right down onto the motor. Figure there is less risk of bending motor shafts that way. I spend part of the weekend finishing, flying and tuning an openpilot copter control FPV project. Should have some updates on the y6 soon. Its early summer and its not too uncomfortable out in the shed of an evening so I can make a bit of progress if work hasn't been too frantic.
There is also this series of motors to choose from