View Single Post
Old Nov 11, 2011, 01:04 AM
junsi is offline
Find More Posts by junsi
iCharger
junsi's Avatar
Joined Mar 2007
1,091 Posts
Quote:
Originally Posted by Thumbolino View Post
Hi,
I have two 106B+ chargers and one of them gives a reverse polarity error when I plug in a 4 cell, 5 cell, or 6 cell balancing connector from a battery. It works fine on a 3 cell connector.

The other charger works perfectly when I plug in any cell count balancing connector, so I know the problem is not battery balancing connector wiring.

I just upgraded the firmware to version 3.14 and that did not solve the problem.
You can press STOP for 3 seconds to monitor the voltage of each cell to see if there is any difference between the displayed voltage and your measured voltage? If different, please check if the battery balance port, the wire from balance board to the charger, and the balance board are damaged?

Junsi
junsi is offline Find More Posts by junsi
Reply With Quote