View Single Post
Old Nov 09, 2011, 11:44 AM
xx29l9 is offline
Find More Posts by xx29l9
Mopar Musclecar fanatic
xx29l9's Avatar
Oregon
Joined Oct 2008
874 Posts
The eyes have it

Here I go again, can't leave well enough alone. If I was to go back to day one on this build, here is a change I would make. The rib that sits right under the windshield has a shape that pushes the chine a little lower than it should be by the time you bend the wood around it. Instead of a smooth line from the bow sweeping down the side of the boat, it has a slight bump in it...Probably could have left it alone and only I would have known. But the more I thought about it I wondered with the model was running at a fairly fast speed if this bump might cause some porposing? That and the fact it was driving me crazy again the more I looked at it made me do something about it. Got out the masking tape and used it to put a new line down the side that I can use the Dremel sander on to bring it to where I want it. Luckily there is plenty of wood in that area to sand on. This will be done on both sides.
xx29l9 is offline Find More Posts by xx29l9
Reply With Quote