View Single Post
Old Nov 05, 2011, 09:47 PM
VoyagerXll is offline
Find More Posts by VoyagerXll
Registered User
VoyagerXll's Avatar
Bloomfield. Nebraska
Joined Jun 2009
58 Posts
I have almost completed my Wot-n-Fokker. I down sized the plans to a 30 inch Wing span. AUW is 12.2 oz I have installed an Emax 1600kv 2805 motor with a 9X5 orange prop. I am quite confident that this set up will be adequate. All that is left is to get the ailerons connected to the servo. I am going to run my control arms above the wing. Not as neat looking but my receiver is where the wires should go, so rather than mess with that will go on top. I am not going to add a landing gear,since I fly in front of my house and do not have a smooth enough area for a landing strip. Too big of stones in the gravel on the drive way to take off on. I liked the "original" Wot-n-Fokker so much that I copied it the best I could. Even if I had the plane done I could not fly as the wind has been blowing really strong the last two days. Hoping tomorrow will be better

Stan
VoyagerXll is offline Find More Posts by VoyagerXll
Last edited by VoyagerXll; Nov 05, 2011 at 09:53 PM.
Reply With Quote