Thread: Discussion Arrow Ghost
View Single Post
Old Oct 29, 2011, 11:10 AM
wyowindworks is offline
Find More Posts by wyowindworks
Just fly it!
wyowindworks's Avatar
Cody, WY
Joined Nov 2007
6,919 Posts
Quote:
Originally Posted by Shaper Dave View Post
My system has been worked out over many years and the results are always good. The key for me is a very thin PVA coat as an aid to the release. Not a full barrier as normally done to stop the resin from touching the surface. Its still 10 coats of Mold Wax then the mist coat.
Sanding the texture is minimal work for me, most people would not notice the texture if they look at the mold.
Press on. I just wasn't sure if you new of some other alternatives. I'm Frekote to the core when making molds.
wyowindworks is offline Find More Posts by wyowindworks
Reply With Quote