View Single Post
Old Oct 27, 2011, 02:22 PM
CX2X3 is offline
Find More Posts by CX2X3
Registered User
Cape Town, South Africa
Joined Jul 2008
25 Posts
I got my 5.5e flashed to XX15e_QUADX_M168 . and also got my LCD working now .. my first flight was not good tho .. the copter seems to be relatively stable the first couple of seconds and then it starts to oscillate/wobble .. I presume my gain on the pitch and roll gyros are too high .. I tried to change these with the LCD/TX but if I power down and up again the settings are back to default .. how do I save the settings?

also what is the difference between ACRO/STABLE/UFO/DEFAULT .. btw if I change this setting via tx and power down and up it is also back to DEFAULT??
CX2X3 is offline Find More Posts by CX2X3
Reply With Quote