View Single Post
Old Oct 27, 2011, 07:33 AM
dt8666 is offline
Find More Posts by dt8666
Registered User
Joined Oct 2005
1,662 Posts
Quote:
Originally Posted by jaccies View Post
Vref= 1.63V
Mike your picture was wrong , the roll gyro is the pitch gyro i think!
I cannot see any bad solder joints , but if i press on the board
it is all smd solder points, i tried to resolder the gyro with a very smaal solder iron, but ni success
If i push on the board the value Diagnostics/Pitch changes back to 886
and after a while it change to 330, 470 etc
So i think i have a bad board
What can we do about it please?...i like to fly that bird

Thanks
the solder blob near the gyro is the point for measuring the vout of the gyro.

when you mention press on the board, any specific part? if that is the board, send it back and we will get it fix.

Thanks
dt8666 is offline Find More Posts by dt8666
Reply With Quote