Originally Posted by mavlo77
I had exactly the same! Genty pull the pushrod upwards while pushing the white stopper down till it meets the plastic servo housing. Not too tight of course....
Then I put a small drop of loctite on top to secure it. It works. The slop is gone.
Just be very careful to push the white "stopper" piece exactly vertically down. I messed up one servo by accidentally bending the very thin cheap soft-metal shaft .... and I could never get it to work correctly again [luckily I have several replacement servos from Marcel's almost-new user-damaged returns]. However, note that the slop seems to have no real effect on actual servo throw, even though one would expect it to have.