Thread: Discussion Dacono rebels
View Single Post
Old Oct 26, 2011, 02:57 PM
Dabdavis2 is offline
Find More Posts by Dabdavis2
The Professor...
Dabdavis2's Avatar
USA, CO, Englewood
Joined Dec 2010
299 Posts
New Thread!!

Hey guys...

This is great-A thread for the homeboys. OK so I have been trying to set up my servo channels for the new Beast on the DX7. Almost got it figured out for the ail but have run into a snag with the elev. Not sure if I am missing something or not but when I split the elevator according to Spektrum using the Aux2, it works but I do not get full movement. When I pull the stick the servos move in tandem, as they should. But when I push up, the servo in the elev goes the opp direction but Aux2 servo still moves in the same direction as before. In other words the servo plugged into Aux2 is only getting 1/2 movement in the same direction with the stick in either up or down position.

Weird...

What am I missing-Anybody got any Ideas..?

D
Dabdavis2 is offline Find More Posts by Dabdavis2
Reply With Quote