View Single Post
Old Oct 26, 2011, 01:42 PM
mavlo77 is offline
Find More Posts by mavlo77
Registered User
mavlo77's Avatar
The Netherlands
Joined Oct 2008
1,227 Posts
Quote:
Originally Posted by caall99 View Post
There is a small piece of white plastic just before the upper tip of the metal shaft. there seems to be a gap between the small plastic thing and the servo housing. Is there anyway to tighten up the slack in these servos?
I had exactly the same! Genty pull the pushrod upwards while pushing the white stopper down till it meets the plastic servo housing. Not too tight of course....

Then I put a small drop of loctite on top to secure it. It works. The slop is gone.
mavlo77 is offline Find More Posts by mavlo77
Reply With Quote