Thread: Discussion Official Blade 450 X 3D Forum
View Single Post
Old Oct 21, 2011, 10:37 AM
mhunter is offline
Find More Posts by mhunter
Suspended Account
Joined Jul 2011
1,197 Posts
Quote:
Originally Posted by FlybarlessMatt View Post
That brings up a good point. I looked at the specs of the cyclic servos and I found they do function at 6V, but the advantages aren't very much IMHO.

http://www.horizonhobby.com/Products...S76#quickSpecs
Amazing how these "real" servos are a full $5 cheaper than the stupid mCP X servos.

But, these servos seem pretty good so far. I have a bunch of flights on my B450 3D and they're holding up fine. And I fly pretty hard...but I haven't crashed YET, either... I'm fully expecting them to strip and I have three Hitec HS65MG servos standing by for when they do. Last I checked, HH didn't even have the replacement plastic gear train parts for those servos.
mhunter is offline Find More Posts by mhunter
Reply With Quote