View Single Post
Old Oct 20, 2011, 05:33 AM
fr3d-nexus is offline
Find More Posts by fr3d-nexus
Registered User
fr3d-nexus's Avatar
France (near the ch'ti village)
Joined Apr 2007
133 Posts
ser 2 connector

hye all,
I want ot connect a remzibi poor gps(gnd-black,5v-red,tx-white,rx-blue) trough the "ser" little white connector on a flyduino board.
I've bought the specific wire @ flyduino.com.

And now I would like to know the connecting diagram of this connector.

I've found the following with a multimeter
from TX1/Rx1/5v/gnd connector (up) to rc receiver pins(down)

"ascii" schematic:
TX1/RX1/5v/gnd

pin6: Ground
pin5: 5v
pin4: TX
pin3: RX
pin2: gnd
pin1: unknow xck?

rc pin reciver

is it correct ?
fr3d-nexus is offline Find More Posts by fr3d-nexus
Reply With Quote