View Single Post
Old Oct 16, 2011, 02:05 PM
bellyup is offline
Find More Posts by bellyup
Registered User
bellyup's Avatar
Australia, NSW
Joined Jul 2011
92 Posts
Resoldering battery leads

Just wondering if anyone can confirm where the battery leads attach to the PCB or provide a photo of theirs if it's the same as the one below.

My son took a battery out and took the wires with it. But I can't tell where they reattach. I've seen a few photos that people have posted here and googled for others and found a few of the spitty and stang but everyone's boards appear slightly differently, but particularly the spitty's.

The one in our P51 is the first picture and the wires I'm sure were attached on top of this board. The closest I found to this was from the hobby lobby site showing a replacement, pictured 2nd. Except it has the 3 extra pin sockets a few here have spoken of, plus there's minor changes in board layout. But comparing the two I'm assuming my leads will go into a similar spot, where there's a black glue blob. But thanks to the white glue blob on the HL example I can't tell where +ve and -ve goes. Any ideas?


bellyup is offline Find More Posts by bellyup
Reply With Quote