Thread: Discussion RVOSD - V5 - reports
View Single Post
Old Oct 13, 2011, 07:37 PM
ScooterInVegas is offline
Find More Posts by ScooterInVegas
Village Idiot!
ScooterInVegas's Avatar
United States, NV, Las Vegas
Joined Apr 2011
1,932 Posts
Quote:
Originally Posted by imdone View Post
Here is a easy one... 2 pins coming from my DL rx and 3 pins going into my rvosdv5. How do I hook it up?
On the DL, Ground on the outside pin on the RVOSD. Signal wire on the DL to the INSIDE pin on the RVOSD. Leave the middle pin on the OSD open.

I took a servo lead and cut off one end and soldered on a JST plug. Plugged the JST on to the DL and put the three wire servo end on the OSD with the center wire cut off (because your only using the two outside pins on the OSD).
ScooterInVegas is offline Find More Posts by ScooterInVegas
Reply With Quote