Thread: Build Log 1st 450pro TT build rev 1.0
View Single Post
Old Oct 07, 2011, 11:50 PM
nese is offline
Find More Posts by nese
Registered User
nese's Avatar
Joined Nov 2010
930 Posts
Build Log
1st 450pro TT build rev 1.0

This revision of my 1st 450pro TT after crashing my original setup sees the following changes:

- Reconfigured wiring to facilitate easier change of parts: Moved Rx to the base of the tail.
- Replaced blades (changed to carbon fibre); new 'Align clone' main shaft; new elevator servo.

The settings I've set up so far are:

Stick position(%) Angle TxOutput(%) RPM

100%(H) +12 95%

75% +8 74%

50% +4 60%

25% 0 45% 3000rpm

0%(L) -4 18%

I'm not sure how it will handle but've gotta wait till the field dries up a little
nese is offline Find More Posts by nese
Last edited by nese; Oct 10, 2011 at 01:12 AM.
Reply With Quote