Thread: Discussion Skywalker 168cm FPV plane
View Single Post
Old Oct 06, 2011, 05:21 AM
heinduplessis is offline
Find More Posts by heinduplessis
Foam Snow
South Africa, WC, Cape Town
Joined Aug 2011
1,328 Posts
Quote:
Originally Posted by cliffkot View Post
An easy method to set and maintain hinge depth before gluing is to pin the hinge after it is inserted in the slot.

....

I challenge you to pull the thing apart without ripping up the control surfaces!

Cliff
Thanks Cliff!! Will give it a bash. Although - looking at the hinge - it seems like a very difficult thing to do. Did I buy too small a hinge?

Also, at the side where the hinge slot is supposed to be cut on the aileron - the surface is very thin, remember the aileron tapers off towards the wing?!

If you look at the picture below - is it the right side around??
heinduplessis is offline Find More Posts by heinduplessis
Last edited by heinduplessis; Oct 06, 2011 at 05:29 AM.
Reply With Quote