View Single Post
Old Oct 04, 2011, 10:46 PM
DroneBuilder is offline
Find More Posts by DroneBuilder
Registered User
United States, TN, Brentwood
Joined Oct 2010
566 Posts
I have just completed the successful hardware mod of six ExceedRC Proton 30A esc's to work with an MK using i2c control.

The firmware I used was pre-compiled into hex files by ArthurP.

The firmware files were named "TGYPxxA2007v0100TwiNoCalM01.hex" and went through "TGYPxxA2007v0100TwiNoCalM08.hex" (of course, I only used 1 - 6).

The question I have is:

If you implement TC's i2c patch into your newer code (and maybe provide some hex files) would an improvement be realized? if so, I'd be glad to re-program mine. (I have not yet mounted them to a bird to test them in flight, I have only connected them and tested them in MKtools.)

Thank you!
DroneBuilder is offline Find More Posts by DroneBuilder
Reply With Quote