Thread: Build Log 90mm VIPER JET from HOBBYKING
View Single Post
Old Oct 02, 2011, 12:08 PM
vettster is online now
Find More Posts by vettster
"Take Off" eh!
vettster's Avatar
Canada, ON, Beeton
Joined Aug 2008
3,591 Posts
Good News for you guys that want to install gear. I found the perferations that some had mentioned before. Should make cutting out the slots a bit easier.

Heres the pix of the rudder base you guys were asking for

The wing spar is a VERY tight fit. I had to sand both the inside of the fues tube and the outside of the spar to get it in both the wings and the fues.

Better tight than sloppy..in more ways than one
vettster is online now Find More Posts by vettster
RCG Plus Member