Thread: Build Log 90mm VIPER JET from HOBBYKING
View Single Post
Old Sep 29, 2011, 08:08 PM
vettster is offline
Find More Posts by vettster
"Take Off" eh!
vettster's Avatar
Canada, ON, Beeton
Joined Aug 2008
3,594 Posts
Quote:
Originally Posted by pilotrcuk View Post
LOL, looked like you build the servos into the tails, then cut pockets in the fuz, whereas the JT has the servos mounted to the fuz - maybe an easier mod that way? TBH I prefer driving a control surface from the middle, but I'm sure this'll be just fine.
actually.. i mounted the servos 10% into the stabs and 90% in the fuse. They were glued to the stabs(but not much) and then heavily siliconed inside the fuse. I didnt have the room to leave the screw tabs on with the 70mm Jet because of the spars, but on the 90mm, it shouldnt be a problem. So basic;y.. it should look just like the photo of the JT. But I wouldnt want to trust just two screws. Dump the silicone to her inside the fuse.
vettster is offline Find More Posts by vettster
RCG Plus Member