Thread: Build Log Duet Beta Build
View Single Post
Old Sep 19, 2011, 08:06 AM
schrederman is offline
Find More Posts by schrederman
Hot Dawg Glider Pilot
schrederman's Avatar
United States, TX, Weatherford
Joined Nov 2002
8,010 Posts
The slot requires 2 cuts. After the first one, you need to be careful with the second to keep it accurate, because the blade wants to drift toward the first kerf. I use the jig to mark the cuts and I mark them deeply enough to show any inaccuracies in the slot. I have a flat, fine rasp that is only 1/16" thick. It allows me to clean up the slots for a perfect fit. Trying to use the jig with the saw would wear out the jig quickly, and the slots would get wider with each pass.
schrederman is offline Find More Posts by schrederman
Reply With Quote