View Single Post
Old Sep 18, 2011, 03:28 AM
stick08 is offline
Find More Posts by stick08
nothing new under the sun
stick08's Avatar
Joined Jun 2006
177 Posts
Originally Posted by JimDrew View Post
Red/green flash indicates that there is a problem with the RF module talking to our board. This could occur if you attempted to upgrade a v2.x receiver to v3.x firmware. The v2.x firmware receivers require a new RF board, which is why they have to be sent back to us as part of the upgrade.
sorry for my poor English, 4*60 is right : there is not red/green flash only red flash my IFS is V3.8 I didn't attempt any upgrade as it is already V3.8 firmware.
the first part of the video is your Xtremlink rx that works perfectly with normal red flash until TX is on than it change to green. I do the video of the two RX to show that Battery A123 is ok as is the TX.
attached a pic of my new Jet that was suppose to make the maiden today but after this issue on my IFS Graupner RX I have to found the reason before puting in another RX ( maybe a short circuit in one of the servo extension I dont know )
please help
thank you
stick08 is offline Find More Posts by stick08
Reply With Quote