Thread: Discussion esc that can handle 4 servos
View Single Post
Old Sep 17, 2011, 07:04 PM
shultz is offline
Find More Posts by shultz
Registered User
United States, NV, North Las Vegas
Joined Sep 2009
1,075 Posts
Depending on the BEC 3 or 4 inches would have never been enough for my Futaba 9C's with any receiver I owned from futaba or hitec... try and move it away at least the length of the lead off the BEC(6-8 inches average) If you still have problems add the RF choke(not a bad idea anyway) and maybe even use a servo extension if you could get it farther away from the Rx than the BEC lead will allow.
shultz is offline Find More Posts by shultz
Reply With Quote