Thread: Discussion esc that can handle 4 servos
View Single Post
Old Sep 17, 2011, 06:06 PM
newelectro is offline
Find More Posts by newelectro
Jimmy Rc
newelectro's Avatar
Joined Nov 2004
45 Posts
Discussion
esc that can handle 4 servos

I have a dr foamie f15 that I tryed to run 4 hitec 55 servos on. The esc I had was a grayson hobbie 50 amp it said to run a seperate ubec and disconnect red wire from this esc which I did. But after installing ubec servos went crazy and cannot get any range. Uninstalled ubec and went back to 2 servos and is fine. I am running futaba 8u comp radio on 72 mhz has any one else had these problem and what did you do to solve it? I read somewhere that 2.4 is better becuase of this issue. Running 3s 2200 mah lipo.
Thanks for any info
Jimmy
newelectro is offline Find More Posts by newelectro
Reply With Quote