Originally Posted by mumblety-peg
Were the receivers in the fuse? Maybe carbon blocking the signal?
How were you powering the rx? Maybe low voltage?
Very disturbing when this happens
Nope ... completely outside the fuse. Hmmm ... was powering the rx with a receiver pack ... quite possible that its voltage was low. HOWEVER I did check the other servos (all FOUR of them!) in the wing with the same
pack during my "process of elimination" and they all worked fine.
Now this servo is different from the others in that its the only GMD version ... the ones in the wing are SCD and AMD ... so dunno if that means anything.