Thread: Idea B-24D Liberator
View Single Post
Old Sep 13, 2011, 10:11 PM
kevin matthews is offline
Find More Posts by kevin matthews
Registered User
carbondale il
Joined Jan 2007
2,774 Posts
Thank you very much, Bruce. The largest gears I can fit into the fuse is around 1" each. Two 1.5's would require 3" of space inside the fuse. There is that much room but I have to take into consideration the box also and mounting it. As far as different gear sizes for a ration other than 1 to 1, I thought that was against the regulations, no?

Kev

Just checked the plan again, I could fit in a 1.5 diameter with a 1" diameter combination. Which gear would be directly connected to the rubber and which to the prop shaft, or does it matter?

figured it out - the larger gear to the rubber motor.
kevin matthews is offline Find More Posts by kevin matthews
Last edited by kevin matthews; Sep 13, 2011 at 10:26 PM.
Reply With Quote