Thread: Help! Wasp V3 Setup problem
View Single Post
Old Sep 10, 2011, 01:21 AM
Parkflying is offline
Find More Posts by Parkflying
United States, MI, Auburn Hills
Joined Dec 2008
1,087 Posts
Quote:
Originally Posted by ingleburn View Post
Hi Max, The parts I replaced on the Wasp are as follows:

Main shaft set for 4ch for SkyArtec Wasp V3 (WH3-012)
As I had a brand new wasp sitting there I undid The screw holding the frame connector on and used the frame connector, rotor holders and pitch axis on the old 1 as well. Do you think this may be the problem? Thanks in advance for your help.
Is the new WASP you removed the parts from a CCPM version and the older helicopter you are trying to fix a FP version?
Frame connector is totally different for the each of these versions

Max
Parkflying is offline Find More Posts by Parkflying
Site Sponsor
Reply With Quote