Thread: Help! Wasp V3 Setup problem
View Single Post
Old Sep 06, 2011, 06:43 AM
ingleburn is offline
Find More Posts by ingleburn
Registered User
Australia, NSW, Ingleburn
Joined Dec 2009
333 Posts
Help!
Wasp V3 Setup problem

I recently had to replace a main shaft and frame connector on my V3 FP after 1 of the screws holding the rotor holders snapped. Luckily the blades missed my head The problem I have now is that when the servo arms are set at 90 as they should be the swashplate is not level. Am I doing something wrong or am I using a wrong main shaft?



ingleburn is offline Find More Posts by ingleburn
Reply With Quote